I'm going to be doing a few 802.11b/g experiments soon and decided to build another "spider" omnidirectional antenna. They are cheap, easy to build, and pretty rugged. I made my first years ago to get 802.11b through the brick firewall separating two halves of a house. The site explaining the design can be found here:
The components required are cheap and easy to acquire. You need a panel-mount female N connector with 4-hole flange, some wire and a bit of solder. I used #10 house wire (30 amp, orange jacket) for the ground plane and #12 house wire (20 amp, yellow jacket) for the driven element. The N connector was picked up for $1 at a local hamfest, but they're available online.
Tools you'll need:
- Big soldering device (big iron, soldering gun, or small torch)
- Pliers to bend the wire
- Cutters to cut the wire
- "Helping hands," small vise, or lock pliers (the N connector will be hot enough to melt plastic and ruin table finish)
- Round file
- Flat file
- Metric ruler/scale or calipers
What I used:
- Hexacon 100 Watt iron
- Klein/Bell System lineman's pliers (cutter combo)
- Radio Shack "Helping Hands"
- Home Depot hobby files
- $9 Harbor Freight calipers
DSC03059.JPG 181.78KB 1 downloads
The N connector needs cleaned to take solder. If it's a really nice silver-plated one, it should be ready to go. If it's a more common chrome-plated kind, you need to remove the chrome or solder won't stick. Use the round file to remove the chrome from the flange holes and the flat file to remove it around the holes. You should see yellow/gold brass under the chrome.
DSC03063.JPG 171.61KB 1 downloads
Once it's clean, cut your #10 wire into four lengths. They should be at least 40mm long. I left mine much longer to make handling the hot N connector easier. Bend the ends at a right angle with your pliers, so that they can be inserted into the mounting holes on the connector flange.
DSC03065.JPG 187.29KB 1 downloads
Use the holding device to hold the N connector while you solder. DO NOT TOUCH ANY OF THE METAL! Even the ends of the long #10 wires were far too hot to touch.
DSC03068.JPG 128.91KB 0 downloads
Cut a piece of #12 wire for the driven element. It needs to be at least 32mm long, from the end of the N connector flange to the tip of the wire. I cut mine long for easy handling and cut to length later. Make sure it's as square as possible to the N connector.
DSC03069.JPG 175.02KB 1 downloads
Soldering is now finished, and you're ready to trim down the leads to their required lengths. Let the antenna cool down to room temperature first! We're going to cut them to 1/4 wavelength dimensions. Use the handy diagram in the original linked article.
DSC03070.JPG 117.45KB 2 downloads
Cut the driven element a bit long and then file it flat. This will make the cut more precise. You want the end of the element to be as close to flat as possible.
DSC03072.JPG 170.29KB 4 downloads
Bend the ground plane elements to 45 degrees. The original article suggests 30 but reports that people had better results with 45. I used 30 with my first build and then corrected to 45 later on. Once they're bent, measure the leads and cut them. These don't have to be perfectly square, but I filed down the sharp edges.