HPR - HPR1174: Low Tech Fab (PCB Etching)
Posted 30 January 2013 - 07:00 PM
I this episode NYbill talks about etching copper PCB boards at home..
Surface mount breakout board layouts:
FTDI FT232RL Data sheet:
Sparkfun FTDI breakout board schematic:
Tinting fluid (I didn't buy it here. This is just a good pic of the product I used):
Anyone driving through the Capital District of New York, this old, locally owned, electronics shop is still kicking:
A few things I forgot to mention in the episode. The muriatic acid/hydrogen peroxide etching solution can be used multiple times. Store it in plastic or glass containers. The tinting fluid can also be reused. But, it will need to be agitated and or slightly heated (place container in a bath of hot water) before reuse as the mix will settle out.
Go to this episode
Posted 01 February 2013 - 09:11 AM
Hey, Trojan Electronics! Good place, they still stock everything you need for most hobby projects...including tubes! Not open Fridays.
BinRev is hosted by the great people at Lunarpages!